Micro Projector (M20) Setup Instructions

Location of Parts and Controls

MP20-parts-and-controls.png

  1. Projection lens
  2. Focus wheel - Roll left or right to fine tune the image focus.
  3. Volume Up [+] control - Increase the volume output of the projector.
  4. Volume down [-] control - Decrease the volume output of the projector.
  5. Power switch - Slide power switch forward (toward the projection lens) to power the projector on.
  6. System indicator light - This light will illuminate briefly as the device starts up, and will also come on if the projector's battery power is getting low. 
  7. Power indicator light - This light will illuminate red when the projector is connected to power to show that the battery is charging or receiving power.
  8. 3.5mm Audio out port - (Optional) Can be used to connect an external speaker or headphones.
  9. HDMI input - Connect the HDMI cable to this port and a device that supports HDMI video output to project content.
  10. Micro USB power port - Connect the supplied Micro USB to USB charging cable to charge the projector's internal battery or provide the projector with power. The USB cable can be plugged into a USB wall outlet or a USB port on a computer for power. IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours).
  11. Reset button - Press to reset the projector. This button is a small recessed button, so you will need something small, such as a paper clip, to press the button.

Operating the Projector

Charging the Battery

The built-in battery is charged using the included Micro USB to USB cable. The blue system indicator light will come on if the battery power is getting low.

IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours).

Setup

  1. The projector can be powered using the included Micro USB to USB cable or the built-in battery.
    • To power the projector with the Micro USB to USB cable, connect the Micro USB to the projector’s and plug the other end into a USB port. Once connected, the power indicator light will illuminate red on the projector to show it is connected to power.
    • To power the projector with the built-in battery, simply turn the projector on.
      IMPORTANT: Fully charge the battery before the first use (approximately 3-4 hours).
  2. Connect the included HDMI cable to the HDMI port on the projector and the other end to your device.
    NOTE: Some devices may require an adapter to connect to your device.
  3. If desired, connect a speaker to the 3.5mm audio out jack. If no external speaker is connected, the projector's internal speaker will be used for audio.

Powering Up and Viewing Media

  1. Power on the projector by flipping the power switch to the on position.
    • If this is the first time you are using the projector, or if the device has recently been reset, you will need to activate the projector with the activation code from your sales receipt. Not sure how to activate your projector?
  2. Allow the projector 15 to 20 seconds to fully start up and sync with your device.
    NOTE: After syncing with the projector you may see your device’s screen being mirrored by the projector. Some devices may not have this ability, but they can still be used with the projector to project videos, photo slide shows, and some app content (this functionality is app dependent).
  3. Choose the media you would like to view from the menu on your device and play as you normally would.

Image Adjustments

Adjusting the Image Size

To adjust the size of the projected image, simply move the projector farther away from (for a larger image) or move the projector closer (for a smaller image) to the projection surface.

Adjusting the Focus

Simply roll the focus wheel left or right to fine-tune the projected image.

Adjusting the Volume

Adjust the volume output of the projector by pressing the volume up [+] and volume down [-] buttons on the projector respectively.

Troubleshooting: Help Me Fix a Problem

Have more questions? Submit a request

0 Comments

Article is closed for comments.